TRAXXAS Slash Rear CVD Shafts Anodised 6061-T6 with 304 Stainless Joints - SSLA1277RHA by GPM  [SSLA1277RHA]

Aftermarket rear CVD shafts for TRAXXAS Slash

This rear CVD drive shaft set is designed as an aftermarket upgrade for TRAXXAS Slash models and sized for 1/10 scale drivetrains. The assembly uses stainless steel 304 for the axle joints and anodised 6061-T6 aluminium for the shaft bodies to balance corrosion resistance and weight.

The layout emphasises drivetrain protection and longevity. The joints sit within a guarded axle design to cut down on debris ingress and impact exposure. Silicone O-rings at the joint keep shock transfer to the CVD lower during hard landings, and the slightly increased body wall thickness is intended to extend working life while keeping original fitment intact.

Installation tips: intended for rear gearbox-to-wheel connection on the compatible Slash models listed below. Included 3mm steel hex shims are there to dial in wheel hex engagement if required. Verify wheel hex spacing and secure hardware to the original torque specs for your model. Suitable for RC 1/10 applications only.

Ideal when you want a corrosion-resistant rear CVD solution that focuses on joint protection and slightly thicker shafts for improved durability; confirm compatibility before fitting.