Traxxas Slash Short Course Rear Widened CVD and Knuckle Arm SSLA1277RH22 by GPM  [SSLA1277RH22]

Heavy duty rear CVD for Slash short course trucks

This rear CVD drive shaft assembly is intended for Traxxas Slash platforms and is supplied as a 12pcs kit. The assembly mixes hardened steel parts with 6061 T6 aluminium to deliver a robust rear driveline suited to off-road and short course driving.

Engineering highlights summarised from the product notes: hardened 45# steel is used in the CVD with 6061 T6 aluminium interfaces, knuckle arms are 6061 T6 aluminium, and the axle is increased to a 6mm section to better withstand landing forces and high-speed impacts. A spring-steel hex improves hex retention and dedicated bearings are fitted for smoother operation under load.

Included component summary as supplied: CVD + hex ×2 pcs, rear knuckle arm ×2 pcs, bearing 6x13x5 ×4 pcs, screw pin M4x2.5x11 ×2 pcs, set screw 3x3 ×2 pcs. The set arrives ready to install or to use in a rebuild project.

Fit this part as a performance-focused durability upgrade: thicker axles and hardened parts reduce flex and failure risk during aggressive running, while aluminium knuckles help manage unsprung mass for better wheel control.

Recommended when you want a tougher rear driveline for high-impact short course use; verify part compatibility with your specific Slash variant before fitting.