TRAXXAS Tmaxx 3.3 4.5mm Alloy Main Chassis Upgrade - TMX3016V by GPM  [TMX3016V]

TRAXXAS Tmaxx 3.3 #4909 Alloy Main Chassis 4.5mm Thick With Screws - 1pc set - GPM TMX3016V
Price:
AUD$27.05
Brand:
GPM
Model:
TMX3016V
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Heavy-duty alloy chassis for TRAXXAS Tmaxx 3.3

Designed as an aftermarket main chassis for the TRAXXAS Tmaxx 3.3, this 1pc alloy plate ships with mounting screws and aims to be a direct-fit replacement for the factory plate. The layout follows stock screw positions to reduce installation complexity.

The 4.5mm alloy adds stiffness over stock plastic and helps the chassis resist bending and impacts during aggressive driving. Included screws allow immediate installation while retaining original components where useful.

Typical installation steps include removing the original chassis, moving over motor, ESC, servo mounts and any brackets, then fitting and aligning this alloy plate in the standard mounting points; check driveshaft and gearbox alignment before final torque.

Specifications

  • Item Alloy Main Chassis, 4.5mm thick, includes screws, 1pc set
  • Material Alloy
  • Model Number TMX3016V
  • Compatibility TRAXXAS Tmaxx 3.3 #4909

This part is suitable when a stronger, more impact-resistant chassis is needed for a TRAXXAS Tmaxx 3.3 #4909; verify clearance and fit on your truck before hard use.

Does the kit include all bolts required?

The kit ships with mounting screws intended for the stock Tmaxx 3.3 layout; if you have aftermarket spacers or oversized electronics, check lengths before completing installation.

Will this change my suspension tuning?

Because the plate increases chassis stiffness you may notice altered suspension response. Rebalance shock settings and ride height to regain the handling you prefer.

Is there any additional trimming required?

No trimming should be needed for a standard TRAXXAS Tmaxx 3.3 #4909 setup, but always test-fit components before final assembly to confirm clearance.

Can I use the original screws instead?

You can reuse factory fasteners if they are in good condition, but the supplied screws are chosen to suit the alloy plate thickness and mounting holes.

Copyright © 2008-2026 rcjaz.com.au All rights reserved