TRAXXAS Tmaxx 3.3/1.1 Gearbox Output Bearing Clamp - TMX1011A by GPM  [TMX1011A]

Reinforced alloy clamp for Tmaxx output bearing

This alloy output bearing clamp is an aftermarket upgrade for TRAXXAS Tmaxx models and is identified as TMX1011A. Intended as a replacement for softer gearbox components, it fits the output bearing area on the Tmaxx 3.3 and Tmaxx 1.1 gearboxes and is supplied as a single piece.

The clamp secures the output bearing to keep axial movement to a minimum and reduce play at the gearbox output. Alloy fabrication improves resistance to wear and deformation during normal RC operation, helping the driveline remain true under load.

To install, open the gearbox cover to access the output bearing, remove the old clamp and fit the alloy replacement, using the factory fasteners to secure it. Verify bearing spin and check seating during an initial bench run to confirm correct installation.