TRAXXAS Tmaxx Rear Bulk Head Side Plates TMX1013 for Upgrades by GPM  [TMX1013]

Durable alloy rear side plates for Tmaxx use

This alloy rear bulk head side plate set suits TRAXXAS Tmaxx platforms and is identified by model TMX1013. The kit replaces the original rear bulk head side panels and includes the screws, pins, collars, lock nuts and E-clips listed in the product title so you can complete the swap without extra parts hunting.

Constructed from aluminum alloy, the plates increase chassis stiffness relative to stock plastic components while remaining appropriate for common off-road and bashing tasks. They are intended as a chassis reinforcement and tuning upgrade, not as a replacement gearbox or suspension assembly.

Notes on fitment and setup:

• Compatibility: intended for TRAXXAS Tmaxx 3.3 and Tmaxx 1.1 vehicles; confirm your rear bulk head arrangement before fitting.
• Fitment: direct-replacement side plates that use the supplied hardware; follow standard rear bulk head removal and refit procedure when installing.
• Tuning influence: alloy plates stiffen the rear, improving lateral stability and throttle response while reducing some suspension compliance on very rough terrain.
• Maintenance: check fastener torque and E-clip seating after initial runs and again periodically to prevent looseness.

Ideal for replacing worn stock parts or tuning chassis balance, this alloy rear bulk head side plate set is a straightforward aftermarket upgrade for Tmaxx 3.3 and 1.1 setups and comes with the hardware needed for installation.