Traxxas TRX-4 Axle Skid Guard Accessory - JR-TRX440 by Jazrider  [JR-TRX440]

Traxxas TRX-4 Stainless Steel Front/Rear Axle Gear Box Bottom Protector Guard
Price:
AUD$8.73
Brand:
JAZRIDER
Model:
JR-TRX440
Condition:
Brand New
Available in shop
Write a review

Axle Underside Armor for TRX-4

This precision stainless guard protects the lower face of front and rear axle gearboxes on the Traxxas TRX-4, aimed at scale crawling and trail runs. The plate adds abrasion-resistant coverage while not implying any drivetrain upgrades or changes to mechanical performance.

Fitment is specifically for TRX-4 axle housings and the unit is intended to be mounted to existing factory points beneath the axle. Verify clearance and suspension travel before final tightening to avoid binding or interference.

Deploy the guard when running technical trails, rock gardens, or obstacle courses to prevent underside gouging; it is an aftermarket protection accessory for scale and trail-focused builds.

Will this change my suspension setup needs?

Adding mass at the axle lowers the center of gravity and may require slight suspension damping or spring adjustments to maintain desired articulation and handling characteristics.

Should I trim anything on my axle to fit it?

The guard is designed for factory TRX-4 mounting locations; trimming should not be necessary for stock axles, though custom setups may need minor clearance checks or adjustments.

Does this require special tools to fit?

Standard hand tools for small stainless fasteners are typically sufficient; use appropriate bit sizes and consider threadlocker to keep screws secure under trail vibrations.

Copyright © 2008-2026 rcjaz.com.au All rights reserved