Traxxas TRX-4 Chassis Bumper Mount Protector JR-TRX442 by JAZRIDER  [JR-TRX442]

Traxxas TRX-4 Stainless Steel Front/Rear Chassis Bumper Mount Protector Guard Ver.2 (1pc)
Price:
AUD$10.24
Brand:
JAZRIDER
Model:
JR-TRX442
Condition:
Brand New
Available in shop
Write a review

Reinforcement plate for bumper mounts

Made from stainless steel, this protector reinforces the Traxxas TRX-4 front and rear bumper mount zones to reduce wear and protect the chassis during trail use. It creates a focused metal barrier around the mounting points to guard against abrasion and contact damage.

Compatibility and layout: the part is formed to match the TRX-4 bumper mount area and to use the chassis' existing mounting holes. Verify your TRX-4 configuration and bumper style before fitting to ensure there is no interference with aftermarket accessories.

Tuning and handling: installing the guard increases local stiffness at the mount points and is useful when fitting heavier scale bumpers. Check for any contact changes with suspension travel and steering articulation after installation.

Will this change chassis flex or handling?

The guard adds localized rigidity at the bumper mounts which can slightly alter how the chassis flexes under load. For most setups the change is minor, but verify handling on a test run after fitment.

Do I need to adjust suspension after fitting?

In most cases no major suspension adjustment is required. If you notice contact or binding when the suspension cycles, small trim or shock position changes may be needed to restore full articulation.

Is this suitable with heavier scale bumpers?

Yes, the protector is intended to help preserve chassis attachment geometry when fitting heavier aftermarket bumpers; always check mounting alignment during installation.

Copyright © 2008-2026 rcjaz.com.au All rights reserved