These front C-hubs are provided as an RC-scale replacement intended for Traxxas TRX-4 installations. The component functions as the steering knuckle mount and affects front axle geometry, load paths, and serviceability on scale trail and rock-crawling rigs.
Compatibility is specified for the TRX-4 chassis; double check alignment with your axle housings and spindle orientation before installation. The listed finish is black and the design is noted as heavy duty.
Installation typically swaps in for the stock C-hubs using existing mounting points and hardware, though inspect screw lengths and thread engagement to avoid interference. While fitting, check steering linkage clearance and ensure servo horn and tie-rod angles maintain intended steering travel to prevent binding.
As a chassis-level tuning part, these C-hubs can influence caster, toe under load, and steering feedback. Make measured changes and validate performance with bench checks and low-speed testing before full trail use.
Fit these C-hubs when you need a heavier-duty replacement for TRX-4 trail rigs, and recheck steering geometry and clearances after installation to tune handling.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
