TRAXXAS TRX-4 Front & Rear Bumper D-Rings, Aluminum Upgrade - JR-TRX403-BK by Jazrider  [JR-TRX403-BK]

Traxxas TRX-4 Aluminum Front/Rear Bumper D-Rings (Black)
Price:
AUD$9.06
Brand:
JAZRIDER
Model:
JR-TRX403-BK
Condition:
Brand New
Available in shop
Write a review

Front/rear bumper D-rings for TRX-4 scale rigs

The JR-TRX403-BK is an aluminum D-ring set built for the front and rear bumpers on TRAXXAS TRX-4 crawlers. These parts create clear, scale-accurate tie-down spots for recovery gear and exterior enhancement while leaving bumper geometry and clearance unchanged.

To fit: align the D-ring with the bumper's factory D-ring mounting holes and fasten with the vehicle's existing hardware or the correct replacement screws. Standard hobby drivers are sufficient and a quick fit check ensures the rings sit flush to avoid rubbing or interference.

On the trail these D-rings act as aesthetic recovery anchors with negligible weight gain, so they do not change tuning or suspension response. Use them for shackles, straps, or light tow points during scale crawling and photography sessions.

Do these change vehicle balance or require retuning?

No significant effect on balance or tuning is expected. The parts are light and intended for scale detail; if you add heavy accessories simultaneously, reassess weight distribution.

Any clearance issues to watch for when fitting?

Check that the rings sit flush and do not contact tires or suspension links during full articulation. Minor repositioning of the mounting screws can correct alignment if needed.

Are they suitable for serious recovery work?

They are designed for scale recovery use and light trail assistance. For heavy recovery tasks, use rated hardware and reinforced mounting points engineered for load.

Copyright © 2008-2026 rcjaz.com.au All rights reserved