TRAXXAS TRX-4 Trail Battery Hold Down Plate - JR-TRX407-BK by Jazrider  [JR-TRX407-BK]

Traxxas TRX-4 Aluminum Battery Hold Down Holder Plate (Black)
Price:
AUD$12.30
Brand:
JAZRIDER
Model:
JR-TRX407-BK
Condition:
Brand New
Available in shop
Write a review

Aluminium hold down built for trail crawling

The JR-TRX407-BK aluminium hold down is an RC-scale accessory tailored for the Traxxas TRX-4 chassis, providing a sturdy option to keep the battery anchored in the vehicle's bay. Finished in black, the plate matches scale styling while remaining low-profile among electronics.

Installation for TRX-4 models is straightforward: the plate aligns to the factory battery area and uses the stock mounting points and fasteners so you can swap or upgrade the original hold-down without modifying the chassis. Use common tools and verify cable routing before final tightening.

As a tuning accessory the hold down helps reduce battery movement that can upset handling and stress wiring during rough sections, aiding in reliable connections and consistent performance on demanding trails.

Will fitting this change the vehicle's balance?

The plate itself is low-profile and intended to hold the battery in place; it should not significantly alter centre of gravity, but securing the pack closer to the chassis can improve handling consistency on technical terrain.

Any tips for keeping wiring clear?

Route cables away from the plate edges and fasteners, secure them with ties if needed, and check clearance during suspension travel to avoid chafing.

How should I torque the mounting screws?

Tighten evenly and moderately; avoid over-torquing which can damage threads. Confirm the plate holds the pack firmly and recheck after a short driving session.

Copyright © 2008-2026 rcjaz.com.au All rights reserved