TRAXXAS X-Maxx +1mm Wheel Hex Claw Aluminium TXM006/+1 by GPM  [TXM006/+1]

Hex claw upgrade for X-Maxx wheels

These aluminium wheel hex claws are specified for TRAXXAS 1/8 X-Maxx and come as a pair with a +1mm offset to change wheel engagement. They act as direct replacements that mate with standard X-Maxx hubs while concentrating the modification on wheel alignment and clamping integrity.

The small offset is useful to prevent tyre rub, help fit aftermarket rims, or fine-tune track width for improved handling. Aluminium provides greater dimensional control and resistance to wear compared with plastic hexes, which supports reliable wheel mounting under load.

Installation is straightforward: remove wheel and original hex, fit the aluminium claw onto the hub, ensure it is flush, then refit and secure the wheel following original procedures. Always check wheel runout and retention with a short test run before extended use.

For off-road and trail setups, this +1mm aluminium hex claw offers a simple means to adjust wheel fit and improve long-term wear characteristics without modifying existing hubs.