TRAXXAS X-MAXX #45 Hardened CVD Wheel Shafts Upgrade TXM812160S by GPM  [TXM812160S]

Upgraded #45 CVD components for X-MAXX

This four piece hardened steel #45 CVD and wheel shaft set is offered as an upgrade for TRAXXAS X-MAXX drivetrains that need better resistance to wear when run on 6s or 8s power. The kit prioritises durable material and revised geometry over cosmetic differences.

Notable specification changes include a 1.5mm thicker body section and a 0.5mm larger diameter shaft pin, together with an increased outer diameter at the inner wheel joint relative to stock. The black finish and hardened steel construction reduce the chance of bending and premature breakage with higher-output battery and motor setups.

Installation is a direct swap of the joint bodies and wheel shafts and is suitable for front or rear fitment; standard hub and CVD retainer removal is required. For vehicles upgraded to 6s or 8s, use this kit as a tuning-stage replacement to lower maintenance intervals and maintain consistent power transfer under load.

Select this set to strengthen the drivetrain on a TRAXXAS X-MAXX when increasing voltage or to replace worn stock components for reliable operation.