TRAXXAS X-MAXX Front Rear Wheel Joint Hardened Steel STXM039/1 by GPM  [STXM039/1]

This hardened steel wheel joint suits TRAXXAS X-MAXX 6s setups and is supplied as model STXM039/1. It is intended as an aftermarket replacement or upgrade for front or rear CVDs where a steel part is preferred instead of the stock component.

Design highlights: the CVD body thickness is 1.5mm, the shaft pin has been increased by 0.5mm over the original, and the outer diameter is raised from 17mm to 18mm. Those adjustments change how loads are distributed around the hub and can help transfer power more effectively under load.

Fitting notes: the item is sold as 1 pcs for use in front or rear wheel locations on X-MAXX platforms running 6s. Verify hub fitment and driveshaft alignment when installing, as the thicker pin and larger OD may require minor shim changes or clearance tweaks.

Application: choose this joint when seeking a steel replacement to tune drivetrain feel, stiffness, and load behaviour at the wheel end for heavier or more demanding RC use.