A three-piece aftermarket dogbone kit for TRAXXAS X-MAXX, referenced as TXM1160S/1. The dogbones are made from steel #45 to offer a stiffer option than standard-diameter parts.
Dimensions and hardware: the shaft transitions from 5.5mm to 7mm to resist bending under high load, with end pins sized at 3.5mm diameter. The set includes 1 pcs 3.5-thread steel collar and 1 pcs 3.0x20 steel pin together with the dogbones.
Usage advice: these steel dogbones are intended for demanding off-road and rally-style running where a beefier shaft reduces flex and improves drivetrain consistency. Verify hub and axle clearances on your X-MAXX before fitting, confirm the 3.5mm pin fits correctly, and recheck retention hardware after test runs.
Copyright © 2008-2026 rcjaz.com.au All rights reserved