TRAXXAS X-MAXX Rear Wheel Hex Claw +3mm with Brake Disk TXM006R/DISK Upgrade by GPM  [TXM006R/DISK]

Rear wheel hex upgrade in aluminium

This precision aluminium rear wheel hex claw, complete with a machined brake-disk face, is an aftermarket upgrade compatible with TRAXXAS X-MAXX hubs. The component provides a fixed +3mm offset to subtly widen track and a solid contact surface to improve alignment under load.

The aluminium design reduces deformation at the wheel seat compared to original plastic hexes, delivering more consistent tyre placement across tyre changes and heavier motor outputs. The brake-disk surface is supplied as a locating/mounting face and does not interfere with your vehicle's brake hardware.

Installation notes: installs into the rear hub position for TRAXXAS X-MAXX using the same retention arrangement as factory parts. Fit with the correct screw sizes and torque values to avoid thread or stud damage, and confirm wheel runout after fitting. Inspect the mating faces and threads periodically, and follow drivetrain guidance on thread locking where appropriate.

For tuners refining X-MAXX handling, this aluminium hex claw gives a firmer wheel seat and a +3mm offset to help tune stance and lateral stability without changing hub geometry.