TRAXXAS XO-1 Rear Arm Bulk Aluminium Upgrade XO009 by GPM  [XO009]

TRAXXAS Xo-1 Aluminium Rear Arm Bulk - 1pc set - GPM XO009
Price:
AUD$5.01
Brand:
GPM
Model:
XO009
GTIN:
4894538035353
Condition:
Brand New
2 Reviews
Write a review
alt="TRAXXAS Xo-1 Aluminium Rear Arm Bulk - 1pc set - GPM XO009" title="TRAXXAS Xo-1 Aluminium Rear Arm Bulk - 1pc set - GPM XO009"
alt="TRAXXAS Xo-1 Aluminium Rear Arm Bulk - 1pc set - GPM XO009" title="TRAXXAS Xo-1 Aluminium Rear Arm Bulk - 1pc set - GPM XO009"
alt="TRAXXAS Xo-1 Aluminium Rear Arm Bulk - 1pc set - GPM XO009" title="TRAXXAS Xo-1 Aluminium Rear Arm Bulk - 1pc set - GPM XO009"

Aluminium rear arm bulk for high speed use

This is an aluminium rear arm bulk built for the TRAXXAS XO-1 platform, supplied as a 1pc set (XO009). It replaces the stock rear bulk with a direct aluminium component for maintenance, setup changes and durability testing during fast runs.

The part is intended for TRAXXAS XO-1 compatibility; double check hole spacing and suspension clearance against your current setup before installing. This is an aftermarket hop-up designed to work with the XO-1 chassis.

Installation advice: keep the original mounting hardware when possible, confirm alignment through the full suspension travel range, inspect mating surfaces for signs of wear, and retorque fasteners to the vehicle makers recommended settings. Fit as a direct replacement when adjusting chassis handling.

 

Product Reviews
2 Reviews
rating
Just finished building a 4-tec 2.0 with GPM parts. SOOO beautiful. After having a bad experience building a wltoys this summer it was nice to once again do another build using GPM parts. The website is nothing to brag about but, the parts are top quality.
rating
Once again it was a pleasure dealing with GPM customer service to inquire about a part. GPM was able to fill my order in a timely manner. Excellent communication from customer service. Thanks GPM!

Will this bulk reduce flex under heavy loads?

Aluminium typically reduces component flex compared to plastic parts, improving repeatable geometry under load; this can be helpful for high speed stability testing.

Do I need special tools to fit XO009?

Standard metric hex drivers and a torque driver are usually sufficient. Ensure you use the correct torque values and reuse or replace hardware as needed.

Is this recommended for competition use?

It can be used in competition environments where a stiffer rear end is desired, but always verify event rules regarding aftermarket parts and perform setup testing to dial in handling.

Copyright © 2008-2026 rcjaz.com.au All rights reserved