This aluminium front guard is made for Traxxas TRX-4 and Axial SCX10 II chassis and comes fitted with integrated LEDs and recovery D-Rings. It functions as a protective scale accessory and a reliable mount for lighting and small recovery hardware during trail runs.
Compatibility is restricted to the platforms listed above: Traxxas TRX-4 and Axial SCX10 II. The bumper attaches to the chassis front mount points and will replace or supplement the OEM bumper; always check your chassis' hole pattern prior to installation. Normal hobby tools will handle the light bracket work required.
Installation guidance: remove the stock bumper, sit this bumper over the existing mount holes, secure with the supplied or matching hardware, and run the LED wiring to a suitable low-voltage source such as a lighting switch or accessory output. Verify LED polarity before finalising and keep wiring clear of moving steering or suspension components. Use the D-Rings for scale recovery scenarios only, not for heavy-duty towing.
Impact on tuning: by providing a firm platform for lights and scale kit, the bumper adds front mass that may slightly change approach angles and balance; minor shock or preload adjustments can usually compensate for any handling differences in crawl-focused setups.
Opt for this aluminium front bumper if you want a sturdy, scale-accurate accessory that combines protection, lighting, and recovery points for TRX-4 and SCX10 II platforms while keeping installation and setup straightforward.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
