TT02 Front/Rear CVD 33mm Steel #45 Swing Shaft STT2233 for Tamiya by GPM  [STT2233]

33mm CVD swing shaft for front and rear TT02

This aftermarket swing shaft replaces the stock driveline shaft on Tamiya TT02 series models. Supplied in a 33mm front/rear configuration and produced from Steel #45, it offers a practical balance of strength and wear resistance for everyday RC use.

The shaft transmits drive through the constant-velocity joints while allowing suspension travel. Choosing a Steel #45 shaft helps limit bending under load, preserving gear mesh during spirited driving or when using higher-torque power systems.

Fitment advice: the shaft is intended as a drop-in replacement for TT02 CVD housings and standard hardware. Inspect set screws, retaining clips, and driveshaft cup clearance, and verify spline seating before final torqueing. Follow original recommendations for threadlocker and service adjacent 走珠軸承 and joint boots when installing new driveline parts.

This shaft is suitable when you want a durable steel replacement for TT02 front or rear CVDs that supports consistent driveline behaviour; always confirm fitment and service nearby components.