This RC alloy front and rear shock tower set includes an integrated body mount and is supplied as one piece. It is intended for HPI Bullet platform models designated Bullet 3.0 MT and ST according to parts references. Manufactured from machined alloy, the towers replace plastic factory mounts to provide a firmer mounting surface for shock absorbers and the body mount while keeping added weight minimal.
The towers lock the top of the suspension assembly, help retain consistent shock geometry under load, and create a solid anchor for the body mount. Check that your chassis matches the Bullet 3.0 configuration and that the mounting holes line up before attempting installation. When removing stock parts and fitting alloy components, take care to avoid damaging threaded holes or related fittings.
Fitting notes: install at the original shock tower positions using the vehicle's factory mounting points and hardware unless your chassis documentation specifies alternate fasteners. Because alloy mounts are stiffer than plastic, re-check shock damping and ride height after installation to fine tune handling.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
