Upper Deck Plate compatible with Auper D6, Red Anodized - SAK-D6808E/RE by 3Racing  [SAK-D6808E/RE]

Stiffness tuning for the Auper D6

The SAK-D6808E/RE is an anodized red aluminum upper deck mount made for the Auper D6 chassis. As an accessory for scale RC use, it creates a repeatable mounting interface that affects chassis rigidity and the transfer of loads between front and rear.

Experienced builders will find installation straightforward: align the mount to the Auper D6 mounting points, confirm clearance near the radio tray and battery, and tighten fasteners gradually to avoid stressing the chassis. Where possible, reuse compatible kit hardware or follow the kit's recommended fastener specifications for best fit.

From a performance tuning standpoint, changing the upper deck mount modifies local rigidity of the center chassis plate. Use it to dial in roll centre sensitivity, reduce chassis twist under load, or stiffen the mid‑section for specific track surfaces. Implement measured changes and evaluate with controlled test runs.

Care is minimal: keep the mount surfaces clean, inspect for deformation after intensive runs, and protect the anodized finish from abrasive chemicals. Verify the part matches your Auper D6 layout before fitting to model vehicles only.