Upper Link Mount for AX10 Scorpion AX10-31 by 3Racing  [AX10-31]

Upper link mounting for AX10 Scorpion

This upper link mount is intended for the AX10 Scorpion scale chassis and carries the AX10-31 designation. It replaces the factory upper link mounting location and functions as the attachment point for the upper suspension link on front or rear assemblies.

The mount secures the upper link and plays a part in roll centre and camber behaviour by defining the link geometry relative to the axle housing and chassis. In the stock position it retains original geometry, while repositioning gives a repeatable way to tune suspension characteristics.

Installation is uncomplicated for experienced builders: remove wheel and body as needed, remove original mount hardware, fit the replacement part in the same location and torque fasteners to the vehicle maker's recommended values. Verify alignment and link articulation after fitting and confirm hardware compatibility before a test run.

Sold as an accessory for suspension tuning and routine maintenance on AX10 Scorpion scale models and intended for hobby use only.