WR8 Compatible Rear Anti-bend Plate BMT009 for Bullet 3.0 upgrades by GPM  [BMT009]

Rear anti-bending reinforcement for Bullet 3.0

This aluminium rear plate is an aftermarket replacement for Bullet 3.0 and WR8 variants, supplied as a single alloy unit. It is intended for nitro touring cars where limiting rear flex helps keep suspension geometry stable under load.

The design bolts into the original mounting holes so no irreversible chassis modifications are required, replacing the stock rear brace with a stiffer link between the rear tower and chassis. In practice this reduces unpredictable toe and camber movement during hard cornering, aiding fine tuning of rear traction and handling balance.

Fitment advice: check the plate against your chassis code and tighten screws evenly to avoid concentrating stress. Verify clearance around the fuel tank and exhaust system on nitro layouts before final torque. The part is intended as a direct one-piece replacement for the rear assembly on compatible Bullet 3.0 and WR8 models.