WT-01N Aluminium Completed Tie Rod WTN160 for Tamiya by GPM  [WTN160]

Tamiya WT-01N Aluminium Completed Tie Rod - 1set - GPM WTN160
Price:
AUD$18.46
Brand:
GPM
Model:
WTN160
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Completed alloy tie rod for WT-01N setups

The GPM WTN160 completed tie rod is an aluminium steering linkage made for the Tamiya WT-01N chassis, supplied as a plug-in replacement for factory steering links. The alloy assembly connects the servo output to steering knuckles on 1/10 scale monster trucks using the WT-01N layout and gives a firmer feel under load.

Fitting is a routine task for hobbyists: remove the stock rod ends, install the finished aluminium assembly into your existing ball cups or rod ends, and centre the servo to establish neutral steering before running. Use standard hobby tools to confirm thread engagement and torque; avoid over-tightening to preserve thread and ball cup integrity.

Can I adjust the length of the WTN160 tie rod?

The assembly is provided at a set length but you can adjust toe using the threaded rod ends if your setup allows; verify the thread engagement before trimming or locking down.

Will this improve steering stiffness?

Upgrading from plastic or worn stock links to an aluminium completed tie rod typically increases rigidity and reduces flex in the steering system, giving crisper response.

Do I need new ball cups with this part?

If your existing ball cups and rod ends are in good condition they will work with the WTN160; replace any worn or cracked cups to ensure reliable steering operation.

Copyright © 2008-2026 rcjaz.com.au All rights reserved