XRAY 303089 T3 Rear Shock Tower 3.0mm Graphite Upgrade  [XR-303089]

XRAY 303089 T3 Shock Tower Rear 3.0mm Graphite
Price:
AUD$64.03
Brand:
XRAY
Model:
XR-303089
Condition:
Brand New
Write a review

Reinforced Rear Shock Tower for XRAY T3 Cars

The XRAY 303089 rear shock tower is a direct-fit spare for T3 vintage RC cars. Built from 3.0mm graphite, this component adds chassis strength while keeping the overall weight down, making it a practical upgrade for track or club use.

Strength Without Extra Weight

This shock tower supports the rear suspension and helps maintain consistent handling under load. The 3.0mm graphite construction offers a stiff, lightweight solution that works well with a range of shock and spring setups.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is this compatible with earlier T3 revisions?

It is intended for standard T3 rear mounts. For very early or heavily modified revisions, verify hole spacing against the XRAY 303089 before fitting.

Will this change rear traction?

Increasing rear stiffness with 3.0mm graphite can sharpen turn-in and stability. Adjust shock damping and spring rates to fine tune traction for your surface.

Any fitment tips for a smooth install?

Clean mounting faces, reuse correct-length screws, and tighten progressively to avoid overloading holes. Check alignment after installation and run a short test lap to confirm setup.

Copyright © 2008-2025 rcjaz.com.au All rights reserved