XRAY 303717-O Aluminium Left Side Lower Suspension Holder Low  [XR-303717-O]

XRAY 303717-O - Aluminium Lower 2-piece Suspension Holder - Left - Low
Price:
AUD$38.56
Brand:
XRAY
Model:
XR-303717-O
Condition:
Brand New
Write a review
alt="XRAY 303717-O - Aluminium Lower 2-piece Suspension Holder - Left - Low" title="XRAY 303717-O - Aluminium Lower 2-piece Suspension Holder - Left - Low"

Left Lower Suspension Holder Built from 7075 T6 Aluminium

The XRAY 303717-O Aluminium Lower 2-piece Suspension Holder is machined from Swiss 7075 T6 aluminium to deliver strong, lightweight support for the left suspension arm. Its construction helps maintain alignment under load.

Best for Low to Medium Grip Asphalt

When track grip is limited, fitting this lower holder drops the arm anchor point and increases tyre loading for improved traction and steadier turn-in response.

Compatible Components

Combine this left holder with the compatible aluminium holder (#303716-O) and the low rear aluminium holder (#303722-O) to keep your suspension balanced front to back.

Note on Finish

Anodising shades may vary slightly from part to part, so finish colour can differ between units.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Does this require any setup changes after fitting?

Yes. After fitting, you should check ride height, camber and toe and make small adjustments to restore desired handling balance.

Are there any special tools needed to install it?

Standard RC hex drivers and a torque driver are sufficient. Use the correct screw sizes and follow recommended torque to avoid part damage.

Will this change front-end feel at slow speeds?

You may notice a firmer, more engaged front-end feel during slow cornering due to increased tyre loading; tune damping and roll stiffness if needed.

Is the XRAY 303717-O compatible with foam or rubber tyres?

Yes. The holder alters suspension geometry independent of tyre construction, but you may need to adjust setup to match the tyre compound and track surface.

Copyright © 2008-2025 rcjaz.com.au All rights reserved