XRAY 305924 Narrow 24T Pinion - Hardcoat Aluminium  [XR-305924]

XRAY 305924 Narrow Pinion Gear Aluminum Hard Coated 24T/48
Price:
AUD$27.31
Brand:
XRAY
Model:
XR-305924
Condition:
Brand New
Write a review

Designed for Lightweight Efficiency

The XRAY 305924 Narrow Pinion Gear is manufactured from aircraft duraluminum to cut unnecessary mass while preserving structural integrity. It is 1.5mm narrower and about 25% lighter than typical pinion gears, helping reduce rotational inertia.

Precision Ground for Concentricity

Produced on a specially adapted precision gear machine, each pinion meets tight concentricity tolerances. The production flow includes chamfering of edges, a controlled run-in, and a hardcoat finish to resist wear and keep tooth geometry consistent.

Broad Spur Compatibility

Engineered to run with a wide spectrum of spur gears, the XRAY narrow pinion is especially effective when used with XRAY spurs, cutting down on on/off noise and delivering a cleaner engagement feel.

Install and Go

The XRAY 305924 ships ready for installation so you can quickly set mesh and get back to tuning. It is a straightforward swap for hobbyists chasing precise fit and long term reliability.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Do I need special tools to fit this pinion?

No special tools are required beyond common gear spanners and a proper pinion holder to set mesh. Ensure the motor shaft and pinion bore match before tightening.

Is aluminium narrow pinion durable enough for racing?

With its hardcoat treatment and precise manufacturing, the XRAY 305924 provides good durability for most racing scenarios, though extreme abuse will still wear the aluminium sooner than steel options.

How do I check gear mesh after fitting?

Apply a thin film of gear marking compound, spin the drivetrain by hand, and look for even contact across the tooth face. Adjust motor position or shims until contact is uniform.

Copyright © 2008-2025 rcjaz.com.au All rights reserved