XRAY M18T Service Ball Bearing Set M18T-28 by 3Racing  [M18T-28]

Team XRAY M18T Full Ball Bearing Set - 3RACING M18T-28
Price:
AUD$14.46
Brand:
3Racing
Model:
M18T-28
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Service bearing pack for XRAY M18T chassis

The M18T-28 full ball bearing set is supplied for the XRAY M18T 1/18-scale chassis to replace worn bearings in hubs and drivetrain parts, helping to recover rolling efficiency and reduce unwanted friction.

Fitting steps are familiar to experienced modellers: remove existing bearings, clean the bore surfaces, then press new bearings in using a bearing press or an appropriately sized outer-race driver to prevent inner-race damage. After seating, check that assemblies turn smoothly before finishing reassembly.

Storing a complete bearing set makes routine checks and pre-event service quicker. Replace bearings showing side play, noise or corrosion. Apply light oils or purpose bearing lubricants carefully, avoiding contamination of mesh gears or clutch faces.

Do these bearings need special tools?

A small bearing press or outer-race driver makes installation safe and repeatable; improvised methods risk damaging the raceways or bores.

How often should I replace bearings?

Replace bearings when you detect play, grinding sounds or reduced free spin; frequency depends on run conditions and maintenance habits.

Can I run these bearings in wet conditions?

Sealed bearings offer some protection, but after wet runs clean and relubricate to prevent corrosion and premature wear.

Copyright © 2008-2026 rcjaz.com.au All rights reserved