XRAY NT1 2nd Gear 23T Hard-Coated Pinion - Arrowmax AM-NT1-338523  [AM-NT1-338523]

Arrowmax AM-NT1-338523 2nd. Gear 23T (7075 HARD)
Price:
AUD$8.48
Brand:
Arrowmax
Model:
AM-NT1-338523
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

2nd Gear Pinion 23T Compatible with NT1

This 23-tooth 2nd gear pinion is an aftermarket part built for the XRAY NT1 platform and sold by Arrowmax as AM-NT1-338523. Crafted from 7075-T6 aluminium with a hard-coated finish, the pinion emphasises steady mesh with NT1 spur gears while reducing rotating mass for predictable driveline behaviour.

Tuning guidance: choose this gear when you need to change the final ratio or when matching a different motor pinion during setup. The pinion fits directly into the NT1 gearbox sequence; verify gear mesh and endplay during installation and check run-in friction before full-throttle use.

Installation pointers: follow the NT1s original clutch/pinion mounting process, hand-tighten to seat then loosen slightly to achieve correct engagement, and ensure the coated face does not rub the spur. Arrowmax offers alternative tooth counts in the same design so you can tune acceleration versus top speed while respecting NT1 drivetrain limits.

Do I need special hardware to fit this pinion?

No special parts are normally required; use the NT1s existing clutch or pinion mounting method and confirm fitment and clearance during the trial fit.

Will the coating affect gear mesh break-in?

The hard coating is designed to resist wear and should not negatively impact break-in if you check mesh and run the drivetrain gently until the gear seats to the spur.

Can this pinion be swapped for a different tooth count?

Yes, Arrowmax supplies the design in several tooth counts so you can alter final ratio; always verify compatibility with your NT1 spur gear before making the change.

Copyright © 2008-2026 rcjaz.com.au All rights reserved