XRAY NT1 Centre Bulk Stiffener, Anodised Red Aluminium - XN1-07/RE by 3Racing  [XN1-07/RE]

Team XRAY NT1 Aluminium Center Bulk - Red Color - 3RACING XN1-07/RE
Price:
AUD$20.18
Brand:
3Racing
Model:
XN1-07/RE
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Centre bulk upgrade for XRAY NT1

This anodised aluminium centre bulk is a direct-fit upgrade for the XRAY NT1 1/10 on-road chassis and carries the designation XN1-07/RE. Machined with a red finish, the part replaces the stock centre bulk to deliver a firmer mounting point in the middle of the chassis while preserving original mounting geometry.

Fitting requires basic workshop skills: remove the existing centre bulk from the NT1, transfer any bearings or retained screws, then secure the aluminium part to the chassis using the factory screw holes. No chassis trimming or drilling is required for compatible NT1 builds.

Intended as a tuning element, the centre bulk affects centre stiffness and overall flex characteristics. Introduce it as part of controlled setup changes and compare handling lap-to-lap to find the preferred balance.

Can I use this on modified NT1 chassis?

It fits NT1 chassis that retain the original centre bulk mounting pattern. If your chassis has been heavily modified at the centre, verify mounting alignment before fitting.

Does the aluminium require special screws?

In most cases the stock fasteners are suitable. Use properly sized hex drivers and avoid over-torquing to prevent thread damage in the chassis.

Will this part affect wear or maintenance?

The aluminium bulk is durable and corrosion resistant thanks to anodising; inspect mounting points periodically and keep fasteners torqued to spec to maintain consistent performance.

Copyright © 2008-2026 rcjaz.com.au All rights reserved