XRAY NT1 High-Performance Ball Bearing Kit BS-XN1/V1 by 3Racing  [BS-XN1/V1]

Team XRAY NT1 Ball Bearing Set - 3RACING BS-XN1/V1
Price:
AUD$30.34
Brand:
3Racing
Model:
BS-XN1/V1
Condition:
Brand New
Write a review

NT1 Performance Bearing Set

This ball bearing set is specified for use with the Team XRAY NT1 chassis and is supplied as model BS-XN1/V1. It functions as a service replacement for bearings used in NT1 drive components and wheel mounts.

Its technical role is to reduce friction at rotating interfaces and maintain reliable alignment of shafts and hubs under load. When replacing bearings, verify seating measurements, clean mating bores thoroughly, and inspect for any wear or damage prior to refitting.

Fitment notes: use even pressure to press bearings into carriers and hubs, avoid angling during installation, and recheck diff and hex clearances once fitted. For upkeep, remove contaminants, check races for corrosion or pitting, and replace bearings that show axial or radial play.

Specifications

  • Item Ball bearing set for Team XRAY NT1 chassis
  • Material Not specified by manufacturer
  • Model Number BS-XN1/V1
  • Compatibility Team XRAY NT1

This bearing kit offers a direct swap option for NT1 owners performing routine maintenance or rebuilds on drivetrain and wheel components.

Do these bearings need shims for preload?

Preload and shimming depend on your diff and hub stack; fit bearings and measure end float, then add shims if your setup requires specific preload settings.

Are replacement races required when changing bearings?

Inspect existing races and housings for scoring or deformation; if damage is present the races or housings should be replaced to ensure proper seating and service life.

Will these bearings lower lap time noticeably?

Lower friction can help rotational efficiency, but overall lap time gains depend on the whole drivetrain, setup, and track conditions rather than bearings alone.

Copyright © 2008-2026 rcjaz.com.au All rights reserved