XRAY T4 53mm BB DJC Steering Block by Arrowmax AM-010071  [AM-010071]

53mm BB DJC block compatible with XRAY T4

The Arrowmax AM-010071 BB DJC block is a 53mm bearing block crafted to fit XRAY T4 linkage configurations. This aftermarket part is intended to interface with 53mm ball link layouts and to replace a like-form ball joint block when required.

Functionally it locates ball ends, enforces correct linkage spacing, and can influence steering geometry and roll centre when changed during setup. Always confirm the 53mm specification on your XRAY T4 links before fitting to ensure compatibility.

Installation is simple for those familiar with T4 linkage hardware: remove the current block, transfer any studs or bearings you need, and secure all fasteners per your chassis practice. Only standard hex drivers are typically required. After mounting, cycle the steering fully and recheck geometry to ensure no binding or interference.

Choose this BB DJC block for maintaining accurate 53mm linkage geometry on XRAY T4 models; treat it as a precision replacement and verify steering and suspension clearance after swap.