XRAY X4F'25 Rear Deck Graphite 2.0 Upgrade - Factory Pro O-XCP023  [FP-O-XCP023]

Price:
AUD$19.32
Brand:
Factory Pro
Model:
FP-O-XCP023
Condition:
Brand New
Write a review

Rear upper deck upgrade for X4F'25

The Factory Pro O-XCP023 is an aftermarket graphite 2.0 rear upper deck made for the XRAY X4F'25 touring chassis. This direct-fit plate is intended to adjust rear section stiffness and help tune vehicle balance for competitive track use.

Used as a tuning upgrade, the graphite 2.0 plate changes how the rear reacts under cornering and weight transfer, and it is often fitted to reduce rear flex and increase stability on medium and high grip asphalt. Pay attention to bulkhead alignment and screw positions during fitment and confirm clearance with suspension and drivetrain components prior to final torqueing.

Assembly notes: remove the factory deck and either reuse the fasteners or fit new hardware, check screw engagement depth to avoid interference, and tighten fasteners gradually to maintain a flat chassis. After installation, inspect toe and droop to make sure binding has not been introduced.

Is this part an OEM XRAY component?

No, the deck is an aftermarket upgrade by Factory Pro for use on the XRAY X4F'25. It is not an OEM XRAY part, so fitment should be checked against your chassis before installation.

Will it make the car understeer or oversteer?

The stiffer rear tends to reduce progressive oversteer and can make turn-in more predictable, though overall handling will depend on the rest of your setup and track grip.

Any recommended fastener practice?

Use correct length screws, replace damaged fasteners, and torque incrementally in a criss-cross pattern to avoid twisting the chassis plate during installation.

Copyright © 2008-2026 rcjaz.com.au All rights reserved