HOBBYWING XRotor 10A ESC (Asian Version A) - 30901010 Off-Road Multirotor ESC  [HW-30901010]

HOBBYWING XRotor 10A(Asian Version A) - 30901010
Price:
AUD$16.33
Brand:
Hobbywing
Model:
HW-30901010
Condition:
Brand New
Write a review
alt="HOBBYWING XRotor 10A(Asian Version A) - 30901010" title="HOBBYWING XRotor 10A(Asian Version A) - 30901010"
alt="HOBBYWING XRotor 10A(Asian Version A) - 30901010" title="HOBBYWING XRotor 10A(Asian Version A) - 30901010"

Stable Throttle Control with XRotor 10A

The Hobbywing XRotor 10A ESC delivers dependable throttle behavior for compact multirotors, focusing on consistent response and simple integration into common flight stacks.

Optimised Multirotor Mapping

With firmware tuned for multicopter dynamics, this ESC refines throttle response and reduces twitchiness compared with generic open-source mappings, helping pilots fly smoother lines.

Straightforward Setup and Adjustments

Most parameters arrive preconfigured to reduce setup time, leaving only timing and a few advanced options for users who want to dial in performance for specific motors.

Lowered Interference on Signal Lines

The included twisted-pair throttle lead reduces unwanted signal pickup, improving control fidelity in environments with high electromagnetic activity or multiple nearby transmitters.

Specifications

  • Continuous/Peak Current: 10A/15A
  • LiPo Cells: 2-3S
  • Output Connectors: 2.0mm Gold Connectors (Female)
  • Size: 32.0x16.7x8.2mm
  • Weight: 9g

The Hobbywing XRotor 10A ESC is well suited to 250-class setups where compact size, predictable throttle and low noise are priorities for weekend builders and club flyers.

Will this ESC work with brushless cinewhoop motors?

Yes, for lightweight cinewhoop motors within the current rating range the XRotor 10A can be used, provided motor draw stays under the continuous limit.

Does the ESC need special calibration?

Basic throttle range calibration is supported and recommended after installation to match your radio and flight controller for consistent idle and full-throttle points.

What mounting practices improve longevity?

Secure the ESC away from direct propwash and use vibration-damping tape or foam pads to reduce stress on solder joints and connectors during hard landings.

Are the connectors ready to solder?

The ESC uses 2.0mm gold female output connectors; ensure your motor leads or adapters match this size before soldering or connecting.

Can I use the ESC on a mini racing frame?

Yes, for 250-class or similar mini racing frames where motor current demands are moderate, the XRotor 10A is a compact and effective option.

Copyright © 2008-2025 rcjaz.com.au All rights reserved