Y2-304A Aluminum Motor Mount for YD-2 Upgrade by Yokomo  [Y2-304A]

Stiffer aluminium motor mount tailored for YD-2

This aluminium motor mount is manufactured as a direct-fit aftermarket option for the Yokomo YD-2 line of 1/10 drift chassis. It forms the structural interface that locks the motor in place and defines its offset relative to the spur/pinion or belt system. The part is intended for model chassis applications and reduces flex where the motor is fastened.

Installation uses the existing motor mount points on supported YD-2 variants. Because motor spacing and fastener patterns vary across DP and MRTC models, verify the alignment of the mount holes to your chassis before final tightening. The aluminium unit replaces the original plastic bracket to provide a firmer mounting point and lower deflection.

In terms of setup this mount helps stabilise motor positioning under load; the increased rigidity aids in keeping pinion-to-spur or belt alignment consistent during high-slip drifting. Always recheck gear mesh or belt tension after installation and again after a short shake-down run to confirm stability.

Use the Y2-304A when you want reduced motor movement and more consistent drivetrain feedback on Yokomo YD-2 platforms; check hole positions and revalidate mesh after initial runs.