YD-2TC Front Graphite Bumper Brace Y2-001CBA by Yokomo  [Y2-001CBA]

Yokomo Y2-001CBA Graphite bumper brace for YD-2TC
Price:
AUD$30.34
Brand:
Yokomo
Model:
Y2-001CBA
GTIN:
0639342211579
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - YD-2 category
Write a review
alt="Yokomo Y2-001CBA Graphite bumper brace for YD-2TC" title="Yokomo Y2-001CBA Graphite bumper brace for YD-2TC"

YD-2TC front impact plate in graphite

This graphite plate fits on the front bumper area of the 2WD touring chassis YD-2TC to reduce chassis damage from impacts. It is made to accept impact forces at the bumper line so that the primary chassis rails and mounting points see less load during an accident.

Installation is direct: the plate uses the existing bumper mounting positions and secures to the bumper assembly to sit between bumper and chassis. There is no requirement for permanent modifications to the YD-2TC other than fitting the plate at the interface.

As a tuning note, the part is intended for protection and not as a handling upgrade; it helps preserve alignment and speed up repairs after impacts but does not replace suspension tuning practices.

Specifications

  • Item: Graphite bumper brace
  • Material: Graphite
  • Model Number: Y2-001CBA
  • Compatibility: MRTC-YD2, MRTC-YD2CK

Compatibility

  • MRTC-YD2
  • MRTC-YD2CK

For racers running a YD-2TC chassis who want a low-mass, easy-fit sacrificial plate at the front, this graphite brace offers straightforward protection and minimal installation time.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Does this influence handling or only protect the chassis?

Primarily it protects the chassis; any handling change is minor because the plate is light. Experienced tuners may notice a marginal front mass change, but it is not a tuning part.

Is fitting reversible if I want to remove it later?

Yes. The plate attaches at the bumper interface using existing hardware and can be removed without altering the chassis permanently.

How should I check the plate after a heavy hit?

After a hard impact, inspect for obvious cracks, delamination, or broken fixing points. Replace the plate if its structural integrity is compromised.

Which chassis does the listing cover?

The product specifies compatibility with MRTC-YD2 and MRTC-YD2CK for use on YD-2TC bumper mounting patterns.

Copyright © 2008-2026 rcjaz.com.au All rights reserved