Yokomo B10-118CPA BD10 Upper Deck Cross Plate Post  [B10-118CPA]

Yokomo B10-118CPA Aluminum cross plate post for BD10
Price:
AUD$31.49
Brand:
Yokomo
Model:
B10-118CPA
GTIN:
0639342202454
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - MRTC-BD10LCRA category
Write a review

Front Upper Deck Support Post for BD10

This aluminium cross plate post replaces the front support point on the BD10 upper deck and provides an alternate mounting position. By changing where screws are fitted and how many fasteners are used you can influence chassis roll behaviour.

The post is intended for hobby-grade 1/10 touring car chassis and is useful during setup sessions when adjusting front-end balance. Try different mounting patterns to find a firmer or more progressive roll feel.

Fitting requires standard RC workshop tools and access to the BD10 upper deck mounting areas. After installation, verify thread engagement and torque settings, then run tests to confirm intended handling changes.

Specifications

  • Item: Aluminum cross plate post for BD10 upper deck support
  • Material: Aluminum
  • Model Number: B10-118CPA
  • Compatibility: MRTC-BD10 / MRTC-BD10A / MRTC-BD10LC / MRTC-BD10LCA / MRTC-BD10LCR / MRTC-BD10LCRA / MRTC-BD11- 1 / MSR-BD11 / MRTC-BD11A-1

Compatibility

  • MRTC-BD10
  • MRTC-BD10A
  • MRTC-BD10LC
  • MRTC-BD10LCA
  • MRTC-BD10LCR
  • MRTC-BD10LCRA
  • MRTC-BD11- 1
  • MSR-BD11
  • MRTC-BD11A-1

Drivers who make frequent setup changes will appreciate this aluminium post as a quick way to alter upper deck support and test roll settings between runs.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What is the recommended fitting procedure?

Remove existing fasteners, align the post with the chosen mounting holes, hand-thread screws first, then tighten to recommended torque. Re-check after a short test run.

Should I change screw count or position first when tuning?

Start by changing screw position for a clear effect, then adjust the number of fasteners if finer tuning is needed. Make only one change at a time to evaluate results.

Any torque values to follow?

Follow manufacturer torque guidance for the BD10 fasteners where available. Avoid over-torquing aluminium parts and verify torque after initial runs.

Can this be swapped quickly between runs?

Yes, the part is simple to remove and refit, making it suitable for quick setup changes between practice runs or during event pit sessions.

Copyright © 2008-2026 rcjaz.com.au All rights reserved