Yokomo B-MAX2 Front Upper Arm Mount Upgrade by Arrowmax AM-MAX2-017  [AM-MAX2-017]

Arrowmax AM-MAX2-017 Upper Arm Mount Front Standard (7075)
Price:
AUD$29.04
Brand:
Arrowmax
Model:
AM-MAX2-017
Condition:
Brand New
Write a review

Precision Front Upper Arm Mount for B-MAX2

The Arrowmax AM-MAX2-017 front upper arm mount is a machined 7075-T6 aluminium component with a blue anodized finish, intended to replace the factory plastic mount on the Yokomo B-MAX2 while retaining original suspension geometry.

Built to reduce unwanted flex and enhance repeatability, this aluminium mount fits the stock front upper arm location and is compatible with existing suspension hardware and ball studs used on B-MAX2 platforms. It benefits drivers looking for steadier steering feedback across multiple runs.

Installation is a direct swap: remove the original plastic mount and install this aluminium unit, reusing the same mounting screws. Because the aluminium is stiffer, expect changes in transient feel and recheck toe, camber, and fastener torque after fitting.

Specifications

  • Item: Front Upper Arm Mount Standard
  • Material: 7075-T6 aluminium, blue anodized
  • Model Number: AM-MAX2-017
  • Compatibility: Yokomo B-MAX2

As a direct metal replacement for the stock plastic piece, this mount is suited to hobbyists and racers tuning Yokomo B-MAX2 cars who want increased stiffness and longer lasting mounting points.

Will fitting this require different alignment settings?

Fitting the aluminium mount can change the transient response, so it is recommended to check and adjust toe and camber after installation to recover your preferred handling.

Does the mount work with aftermarket arms?

The mount is designed for the standard B-MAX2 arm interfaces; most aftermarket arms that follow the stock fitment should be compatible but verify fit before final assembly.

Is the aluminium likely to cause increased wear on ball studs?

A stiffer mounting point can alter loads slightly, but normal ball studs and hardware are still suitable; monitor wear and replace studs if play develops.

Should I change my maintenance routine after installing it?

Continue routine checks of fastener torque and cleanliness; inspect the mount for signs of impact damage but aluminium generally lasts longer than the original plastic part.

Copyright © 2008-2026 rcjaz.com.au All rights reserved