R12 Right-Hand Front Stabilizer Block for R12 Compatible Models - Yokomo R12-17R  [R12-17R]

Yokomo R12-17R Front Stabilizer Block Right for R12
Price:
AUD$6.68
Brand:
Yokomo
Model:
R12-17R
GTIN:
3888
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - R12 category
Write a review

R12 front stabilizer right-hand unit

Supplied as the right-side stabilizer block for the Yokomo R12 chassis family, this unit is intended as a direct replacement or option where the R12 architecture accommodates separate stabilizer blocks. It is compatible with the GT-series option setups shown below.

Effect on handling: the right-side block sets the stabilizer link anchor and affects how the front resists roll. Replacing this block shifts preload and link geometry, which produces incremental changes to cornering balance and front-end behaviour. Use it when fine-tuning roll distribution or to replace a damaged right-side mount.

Fitment notes: the component installs at the stock block position on the front sub-assembly, preserving link alignment. Basic disassembly of the front end is normally required; ensure correct orientation and tighten fasteners to specified torque. No additional parts are provided with this item.

Compatibility

  • GT5-R35
  • GT5-SC430
  • GT3-REA
  • GT3-IS350
  • GT3-B4
  • GT3-CAX
  • GT3-BRZ
  • GT3-AHP
  • GT-B
  • GT5-R2
  • GT5-RS2
  • YR-R12C3
  • YR-R12C31
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Which vehicle models accept this block?

This block fits the Yokomo R12 family and the GT and YR variants listed in the compatibility section, providing direct replacement fitment where separate stabilizer blocks are used.

Will fitting this require other setup changes?

After installation, check stabilizer link alignment and preload; minor tweaks to link lengths or anti-roll settings may be needed to achieve the desired handling balance.

Is extra hardware needed to install?

No extra hardware is included. The part is intended to mount using the original fasteners and location; have basic hand tools to remove the front assembly and refit the block.

Copyright © 2008-2026 rcjaz.com.au All rights reserved