DP-Compatible Flexible Under-Neon Strip SD-FUNR for Drift Shells by Yokomo  [SD-FUNR]

Conforming neon strip for RC drift bodies

The Yokomo SD-FUNR flexible under-neon is made to sit inside the body shell at the front, rear and lower sides to light the underside for show installs. Four chip LEDs per side are mounted to a flexible base so the strip conforms to varying shell shapes without cutting the circuit board.

It draws its supply from your receiver; route the connector to a spare channel or a switched output on a power distribution unit. Because chip LEDs are directional, it is recommended to energise the strip briefly before final fixing to check the visual spread and direction.

Pre-attached double-sided tape on the strip speeds mounting, and the kit extras support tidy wire routing and protection during fitting. Use this neon primarily as a styling enhancement to highlight body lines and undercarriage detail rather than for signaling or illumination while driving.