Yokomo SG-6498 98 Tooth 64 Pitch Spur Gear  [SG-6498]

Yokomo SG-6498 Precision 64 Pitch Spur Gear 98T
Price:
AUD$5.02
Brand:
Yokomo
Model:
SG-6498
GTIN:
11
Condition:
Brand New
Write a review

Improve Gear Mesh with Yokomo SG-6498

The Yokomo SG-6498 is a 98 tooth spur with a 64 pitch cut that helps produce smooth torque handoff in your RC. Its tooth geometry is aimed at hobbyists who tune gearsets for better throttle response and reduced drivetrain noise.

Built for Accurate Engagement

This spur gear is precision made to keep teeth running true under load. Pairing the SG-6498 with a matching 64 pitch pinion gives a secure fit and helps avert premature wear on both gears.

Practical Installation Hints

Fit the correct 64 pitch pinion, set mesh by feel and make small trial runs to confirm there is no slippage. Recheck mesh after a few runs as components can bed in slightly during initial use.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I swap from a 48 pitch to this 64 pitch spur?

No, you cannot mix pitches. A 64 pitch spur requires a 64 pitch pinion; mixing different pitches will cause poor mesh and damage.

Will using a larger spur change gearing a lot?

Tooth count affects overall gear ratio. A 98T spur will lower top speed compared to smaller spurs but can increase acceleration depending on your pinion choice.

What maintenance keeps this gear healthy?

Keep the spur clean, inspect teeth after running on dirty surfaces, and avoid excessive motor timing or overloading that can accelerate wear.

Is this gear suitable for brushless setups?

Yes, it is suitable provided the gearbox and pinion are rated for the torque of your motor and the mesh is correctly set to handle higher loads.

Copyright © 2008-2025 rcjaz.com.au All rights reserved