Yokomo Y2-301EBA Brass Rear Mount for YD-2 - Performance Upgrade  [Y2-301EBA]

Yokomo Y2-301EBA Brass suspension mount
Price:
AUD$30.49
Brand:
Yokomo
Model:
Y2-301EBA
GTIN:
0639342212880
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $46.20 each $-31.43 or -52%
3+ $41.58 each $-33.28 or -36%
Write a review
alt="Yokomo Y2-301EBA Brass suspension mount" title="Yokomo Y2-301EBA Brass suspension mount"

Refine Corner Exit with Yokomo Y2-301EBA Brass Mount

The Yokomo Y2-301EBA brass rear suspension mount is engineered for the YD-2 family. Using brass increases rear-end mass, giving improved drive traction without making the chassis feel sluggish. The lower centre of gravity aids controlled throttle application when accelerating from turns.

Increased Rear Traction

The heavier rear load helps tyres maintain contact during acceleration. This mount weighs 16.5g, about 11.5g heavier than the aluminium version, which translates to stronger rear bite and steadier exit lines.

Set Up Options and Fit

Configured as an E size rear mount, it is designed for rear installation and supports suspension pin distances from 60.8mm to 64.0mm. That adjustable span lets drivers tailor rear balance and tuning for different track surfaces.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will using this mount change tyre wear?

Adding rear weight can alter tyre load and wear patterns, typically increasing rear tyre load under acceleration. Monitor tyre temperatures and camber to manage even wear.

Can I use this with aftermarket uprights?

Compatibility depends on upright design and mounting geometry. The mount follows YD-2 rear dimensions but check clearances and pin locations when pairing with non-standard uprights.

How should I confirm installation is correct?

After fitting, verify suspension pin alignment across the range 60.8mm to 64.0mm, ensure screws are torqued evenly and perform a short test run to check balance before final setup changes.

Copyright © 2008-2026 rcjaz.com.au All rights reserved