Yokomo YOKBM206W Steering Rod End Kit (White)  [YOKBM206W]

Steering linkage rod ends overview

The Yokomo YOKBM206W rod end plastic parts are designed as RC-scale replacements for tie-rod and turnbuckle connections in steering and suspension linkages. These white plastic rod ends give a low-profile connection where a ball end or turnbuckle meets the linkage and are intended for general tie-rod applications rather than a specific chassis model.

As a service component, the parts address slack and wear that appear in steering linkages. Plastic rod ends offer quieter operation and often lower cost compared with metal, at the expense of greater flex. They are commonly chosen when reduced binding and lower weight are priorities, with the trade-off of typical plastic wear characteristics.

Fitting is quick: remove the old rod end from the turnbuckle or linkage, insert the replacement so the ball-seat engages properly, and confirm unrestricted movement through the linkage range. After installing, inspect the joint for excess play and perform a steering centring check. Because the parts suit general tie-rod and turnbuckle setups, verify thread sizes and ball-seat type on your vehicle before fitting to ensure a correct match.

In setup terms, plastic rod ends influence steering compliance and feedback; moving to stiffer or metal rod ends is a usual step when a firmer response is desired. Plastic components can also help absorb minor impacts and limit shock transfer to servos in casual driving situations.