Yokomo YOKIB202BR DIB Steering Bellcrank B Red  [YOKIB202BR]

Yokomo IB202BR - Steering Bellcrank B for DIB/Red
Price:
AUD$27.64
Brand:
Yokomo
Model:
YOKIB202BR
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - DIB category
Write a review

Bellcrank B for DIB chassis replacement

The Yokomo YOKIB202BR is a replacement steering bellcrank B intended for DIB-designated chassis, offered here as an RC spare for the steering linkage. The model number and red colouring are shown in the product title, and it is meant to replace the original when geometry and mounts match.

To fit the part: remove the servo horn and disconnect the linkage, unfasten the existing bellcrank, install the YOKIB202BR in the same orientation, and reassemble while ensuring smooth, symmetrical movement. Use the correct hex driver size and check for binding at extreme steering angles; final setup should include transmitter endpoint and centring adjustments.

As a service component, this bellcrank influences linkage geometry and steering repeatability rather than increasing outright performance. Hobbyists replace it when damage or wear appears, then focus on eliminating free play and confirming toe and steering centring.

Specifications

  • Item: Steering bellcrank B
  • Material: unspecified
  • Model Number: YOKIB202BR
  • Compatibility: for DIB

Install the YOKIB202BR only where the DIB bellcrank geometry matches; always verify fitment and steering alignment after the swap.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will swapping this change my steering ratio?

The bellcrank itself does not alter gear ratios, but changes in pivot spacing or linkage lengths can affect effective steering ratio. Ensure geometry matches the original to keep the same steering behavior.

Do I need to re-adjust turnbuckles after fitting?

Yes, perform a final check of linkage lengths and adjust turnbuckles or tie rods as needed to restore correct toe and steering centring after installation.

Is this suitable for competitive tuning?

This item is a replacement part that maintains steering geometry; tuning gains come from setup changes rather than the bellcrank itself. Use it to restore baseline geometry before applying tuning changes.

Any checks to avoid binding after install?

After assembly, sweep full lock both directions to confirm there is no interference, and verify the servo horn is centred and endpoints are set to prevent mechanical binding.

Copyright © 2008-2026 rcjaz.com.au All rights reserved