Yokomo YOKIB483B1 Rear Belt for DIB 275mm (161T)  [YOKIB483B1]

Yokomo IB-483B1 - FCD x 2.0 Rear drive belt for DIB 275mm Long wheel base (161T)
Price:
AUD$14.17
Brand:
Yokomo
Model:
YOKIB483B1
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - DIB category
Write a review

Rear drivetrain belt for DIB 275mm

This belt serves as a replacement for the DIB 275mm long wheel base chassis and is specified with 161 teeth. The FCD x 2.0 marking indicates the belt profile used to match compatible pulleys and maintain efficient power transfer.

Fitment is limited to the stated DIB 275mm long wheel base configuration; check pulley alignment and tooth engagement before completing assembly. Typical replacement involves accessing the rear drive section, removing the old belt, and routing the new belt so tension is even across all teeth.

In tuning contexts the belt is a service-level item that alters drivetrain feel and efficiency. Monitor for tooth wear, fraying, or tracking issues and replace as needed, then reassess mesh and tension after initial running.

Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.
Yes, a fresh belt can tighten drivetrain response and reduce lash, which may feel like improved acceleration or crisper throttle response.
New belts can settle slightly; expect to retension after a short break-in. Check engagement after a few runs to maintain consistent performance.
Align pulleys carefully, route the belt without twists, and set a slight preload so teeth seat fully without binding across the full 161-tooth span.

Copyright © 2008-2026 rcjaz.com.au All rights reserved