Yokomo YOKRP-011 180mm Sensor Lead for Brushless Motors  [YOKRP-011]

Yokomo RP-011 - Racing Performer 180mm Brushless Sensor Cable
Price:
AUD$8.73
Brand:
Yokomo
Model:
YOKRP-011
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Product summary and use

The Yokomo YOKRP-011 Racing Performer 180mm Brushless Sensor Cable is an RC-scale wiring accessory that connects sensor-equipped brushless motors to ESCs with a sensor input. It serves as a simple, direct sensor link without modifying signal characteristics.

Typical applications are electric RC cars and similar on-road platforms where neat cable runs and reliable sensor signals are required. The 180mm cable length offers a practical balance between routing flexibility and minimal slack.

Installation advice: do not route the sensor lead beside high-current power lines, fasten it securely with small ties or tape, and double-check connector alignment before seating the plug. If needed, adapt or re-terminate the lead following small-wire soldering and insulation best practices.

Note on performance: while the cable itself does not change motor power, keeping sensor wiring tidy and secure helps the ESC receive consistent rotor position data for dependable timing and control.

Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is the cable the length listed in the title?

Yes. The lead is 180mm long as stated in the product title.

Can I change the connectors on this wire?

You can re-terminate the small-gauge wires, but use correct soldering technique and shrink tubing to maintain insulation and prevent shorts.

Will trimming the cable affect sensor function?

Trimming and properly re-terminating the lead will not affect sensor signals if connections are solid and insulation is restored. Avoid damaging the fine conductor strands when cutting.

Copyright © 2008-2026 rcjaz.com.au All rights reserved