Yokomo YOKZCRA3610 3x6x1mm Collar 8-Pack Red  [YOKZCRA3610]

Precision collars for tight spaces

This 3x6x1mm collar from Yokomo is an RC-scale accessory intended for positioning and retaining small shafts and linkage rods in electric model assemblies. The pack contains 8 pcs in red, sized to work with shafts where a compact 3x6x1mm collar is required. The part's role is to set axial position, limit endplay, and help maintain consistent alignment in gear trains, drive shafts, and steering linkages without modifying primary components.

Fitting is quick: slide the collar to the required location on the shaft, check that surrounding components align correctly, then secure it by the method your model supports (press fit, set screw on the mating part, or a retaining clip if applicable). Verify seating after a brief run and recheck positioning when tuning to prevent lateral movement under load.

Tuning advice: use these collars when you need repeatable spacing or small changes to linkage geometry during setup. The 3x6x1mm form factor makes them ideal for confined areas and for keeping small bearings or gears from drifting along shafts.