YZ-4 L5 Rear Suspension Mount compatible with YZ-2DTM - Yokomo Z4-300LRR [Z4-300LRR]

Yokomo Z4-300LRR L5 Arm Aluminum Rear Suspension Mount RR for YZ-4/YZ-2DTM

Price:

AUD$15.83

Brand:

Yokomo

Model:

Z4-300LRR

GTIN:

3888

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the
Spares / Hop-ups - Yokomo - YZ-4 category

Write a review

Description
FAQ

Rear Suspension Mount for L5 Arm

This aluminium rear suspension mount is an optional RC part for the 4WD YZ-4 series, designed specifically for the L5 suspension arm. The rear-side suspension pin spacing is 2mm narrower than the stock rear mount, producing a subtle change to rear geometry without altering the arm itself.

When installed as a set with the front-side mount Z4-300LRF and the slightly longer L5 arm Z4-008RS5, the setup permits track width adjustment while keeping the longer arm length. On high-grip surfaces such as carpet or artificial turf the mount helps create modest chassis roll even with stiffer suspension, aiding turn-in performance.

For balancing front and rear behavior you can also fit the 1mm longer front arm Z4-008F1 to refine weight transfer and entry behavior. The description applies to RC-scale components and setup choices only.

Model Fit

B-YZ2DTMW
B-YZ2CA
B-YZ2DT
B-YZ2DTM
B-YZ4

Remark :

Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is the Z4-300LRR difficult to install on my chassis?

Installation follows standard rear mount replacement procedures for the YZ-4 family. No modification to the L5 arm is required; the mount changes pin spacing but fits into the existing mounting points listed in the compatibility codes.

Do I need to replace the stock arms to benefit from this mount?

No. The mount narrows the rear pin spacing by 2mm without requiring any modification to the arm itself. You can keep stock arms and still achieve the intended change in rear geometry.