YZ-2 Front Bulkhead Gearbox Support Z2-018M2A by Yokomo  [Z2-018M2A]

Yokomo Z2-018M2A Gear box support/Front bulk head mount for YZ-2
Price:
AUD$14.03
Brand:
Yokomo
Model:
Z2-018M2A
GTIN:
0639342216178
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - Off-Road Chassis Parts category
Write a review

Gearbox support — front bulkhead mount

The Z2-018M2A is the gearbox support and front bulkhead mount fitted to the YZ-2DTMW series. Its revised contour differs from prior parts and is designed to influence rear chassis roll behaviour on 1/10 scale on-road touring cars.

As a service or replacement part, it secures the gearbox and front bulkhead while acting as an adjustable element for tuning. Modifying the support geometry changes how lateral and longitudinal loads pass through the rear chassis during cornering, which can be used to tune the car toward more rear rotation or stability.

Installation information: the component mounts in place of the original support on compatible YZ-2 models and connects to the existing front bulkhead. No alterations to the main chassis are required beyond standard removal and refit, and handling effects should be validated with measured testing.

Compatibility

  • B-YZ2DTMW
  • B-YZ2DTM2
  • B-YZ2CAL2
  • B-YZ2DTM2S
  • B-YZ2DTM3
  • B-YZ2CAL3
  • B-YZ2
  • B-YZ2CA
  • B-YZ2DT
  • B-YZ2DTM
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How robust is the Z2-018M2A compared with the original support?

The part is intended as a direct replacement and should perform comparably in service life to the original unit. Inspect periodically for wear or damage, particularly after heavy impacts.

Can I reuse the original fasteners when fitting this support?

Yes, the support interfaces with the same front bulkhead mounting points and standard fasteners can be reused unless they are damaged. Replace any stripped or bent hardware for a secure fit.

What maintenance should I perform after installation?

Check fastener torque after initial test runs, inspect for play at the bulkhead junction, and re-check after a few sessions to ensure continued secure fitting and consistent handling.

Copyright © 2008-2026 rcjaz.com.au All rights reserved